Ryde Receiver / IR remote control / Tuning

[f5iwn]

Hi all,
I recently built a Ryde receiver and I reused an old Sony remote control to use it .... For this purpose, I created a "customized configuration" and shared it with the following post:
viewtopic.php?t=6759&start=60#p38321
All this works but the remote control is quite tricky to use , a little bit too sensitive => I often experience double-clicks which resulst in not being a the right location on the menus
I think I should tune one of the following paramenters in the yaml file ? But which one ?
ir:
repeatFirst: 200
repeatDelay: 100
repeatReset: 400

Any advice on this ?

In advance thank you !

Best 73s
Christophe F5IWN

[radiogareth]

Have you seen here : https://wiki.batc.org.uk/Ryde_Software# ... he_Presets and here where I think this is mentioned too : https://youtu.be/zYhnvmo5dTE?si=aKFYUWEeTESY_Fn2
Gareth