- pLUTO STATS.jpg (101.61 KiB) Viewed 46 times
- DATV EASY 0303.jpg (108.86 KiB) Viewed 46 times
DATV-Easy
Forum rules
This forum is run by the BATC (British Amateur Television Club), it is service made freely available to all interested parties, please do not abuse this privilege.
Thank you
This forum is run by the BATC (British Amateur Television Club), it is service made freely available to all interested parties, please do not abuse this privilege.
Thank you
Re: DATV-Easy
I have also been doing further tests with similar results to yours, see below. The difference being that I still don't have a picture on either of my batc receivers and no rf detected in bandviewer!
Re: DATV-Easy
Well that is clearly working. I assume the PTT is enacted ? (Quite important) You can check on the pluto web page. You can also check the power slider, frequency etc.
At this point I would check for broken SMA leads or reverse-polarised SMA leads.
Mike
At this point I would check for broken SMA leads or reverse-polarised SMA leads.
Mike
Re: DATV-Easy
switched off for a cuppa earlier, what can I say, neither SDR Console or DATVEASY are now working on tx.
Think I'll just go switch on the HF black box, it's a lot less stressful
Mike, Thank you for all of your input to get this dinosaur back on DATV / QO100...to answer your questions, all sma's etc are good and all relevant buttons were activated.
Think I'll just go switch on the HF black box, it's a lot less stressful
Mike, Thank you for all of your input to get this dinosaur back on DATV / QO100...to answer your questions, all sma's etc are good and all relevant buttons were activated.