RYDE front panel JP1 ???

[G4HTZ]

Having surprised myself and successfully put together a portsdown 4 and built the ryde rx …I have a query on the Ryde front panel board .

I have on the GPIO breakout board from the pi ..omitted R2 as stated

I am using the recommended TSOP2438

On the ryde schematic there is a JP1 listed ….but I have not found this anywhere on the Ryde front panel board ….does this link need to be in place somewhere…

https://wiki.batc.org.uk/Ryde_Hardware#Ryde_front_panel

I haven’t fitted the TSOP2438 yet ….but the Ryde seems to respond to the push buttons ok

Any suggestions helpful or otherwise gladly received….but I can find no reference to JP1 anywhere on the wiki pages

Steve G4HTZ

[g0mjw]

Turn the board over and look at the other side... JP1 selects 3.3V or 5V IR sensors. Use a 3.3V sensor and set that jumper to 3.3V.

Mike

[G4HTZ]

Thanks mike
Will check that out next time I venture to the shed shack !!!
Using the recommended device which is 3.3v
Regards
Steve

[g0mjw]

Maybe this helps.

.

RydeFrontpanelBack.jpg (233.53 KiB) Viewed 4932 times

[G4HTZ]

Maybe this helps.

.
RydeFrontpanelBack.jpg

Hi mike
Thanks for that ….obvious now