Table top Posh box for 7inch Portsdown?

[g8lce]

I have a Modero NXD-CV7 / NXT-CV7 Touch Panel sitting here and it has a 7inch touch screen. I also have a 7inch Portsdown with a broken edge to the screen although it still works.
I have taken the NXT CV7 to bits just a bit and it looks like it would be quite possible to mount the screen from the Portsdown into the NXT CV7 and the RPi into the base. That would make a rather nice desktop display with the usb bits elsewhere (in a box underneath?)
These devices are oldish now and appear on Ebay etc. but I also have AMX systems that I use for video switching etc. (AMX 3155 ) so have not jumped in yet.

AMX CV7.GIF (81.19 KiB) Viewed 2978 times

Going price at £65 seems a lot for a case but there may be cheaper sources.

Martin G8LCE

PS I'll update if I decide to jump in with the mod.

[g8lce]

So I have taken the plunge and put the 7 inch touchscreen and Raspberry Pi into the AMX NXT CV7 case. The job was easier than I thought and the screen fitted well. The only problem was the short ribbon cable between screen and RPi, but I had a longer one on a RPi camera so used that. There is a speaker (in fact two ) left in the case and the RPi camera also fitted in.
The video of the step by step is here https://youtu.be/25-VZu8Nj1g

AMX Portsdown.GIF (430.69 KiB) Viewed 2718 times

[g8lce]

When support for Adobe Flash expires soon there may well be lots of the AMX video type equipment coming onto the market so if you are after a case like this don't spend a fortune. I reckon £30 at most.
And if you have some old AMX video selection equipment that uses flash to set it up it may be worth checking you have a computer that will keep running flash after 2020 (may need to alter the clock? )

Martin G8LCE

[g8lce]

For the photographs of this conversion see https://www.flickr.com/photos/supplyima ... 5924701931

Martin G8LCE