case recommendations for use with 7" screen

[m1cdq]

any recommendations for a case to use with a 7" display.
I have printed off a bezel for my display. just getting all the bits together for a build of portsdown.
most of the enclosures I have seen pics of are using the 3" touch screen.
so any pics/ suggestions for a enclosure for my portsdown that will have the 7" touch screen

Cheers M1CDQ

[Nick]

Hello,

I used the RS 754-5998 which is now discontinued, but the RS 754-6008 is available which is the same but 101mm deeper, which may have been a better choice as more room front to back.

Regards,

Nick - G4NKV

Front View.

Front.jpg (1.41 MiB) Viewed 4032 times

Rear View.

Rear.jpg (1.33 MiB) Viewed 4032 times

Inside View.

Inside.jpg (1.98 MiB) Viewed 4032 times

[m1cdq]

the bigger case looks perfect. Not a bad price either.
great pics and a stunning build

[G8PEF]

Thanks for the pics, Nick (and for the question, M1CDQ) - the build looks great

I'm currently considering building mine into a 3u rack-mount case ('card-frame' type with removable/hinged front panel) which I'm about to 'salvage' from a dead unit at work (fortunately, there are very few existing holes in the front panel, and I think the majority of them are in the area that I'll end up chopping out for the display, anyway...

I had a lovely 'instrument case' which I have fitted the 3.5" Portsdown into, which I was hoping could be modified to take the taller display panel. but sadly it's a non-starter. I guess my 2.5" Portsdown 2018 will have to live on

73
John
G8PEF

[m1cdq]

just order the RS 754-6008 case. Its out of stock so its on back order. its going to take me a few months to build it. got to get a few things in stock as well like pcb stand off, sma's , wire, led, get some more dc 2dc buck converters. pcb boards etc. once a have a few things together i will be posting my build progress on here
just for to find my sodding dremel. I think the wife has borrowed it.
from what i have been reading up. you can also get it to control a minitioune for the rx. so i may well build a 2nd minitioune to also fit inside. this will be a part 2 of the project.

[M0IVJ]

Just to add another option. I used one of the cheaper, Chinese blue boxes. Outer Size: 305 x 282 x 122mm/12 x 11.1 x 4.8inch(L*W*H).
The 7 inch screen fits nicely on the front. I replaced the steel panels that came with the box for 3D printer ones. The steel ones are too difficult for me to cut .

Portsdown3_small.jpg (123.84 KiB) Viewed 3773 times

Portsdown1_small.jpg (177.04 KiB) Viewed 3773 times

73s John M0IVJ

[m1cdq]

just got the same case as RS messed up on my order
Im been cheeky do you have the stl for the front panel mount for the screen. As i printed one of thingivers for the rs one which does not fit this case as the edges of the screen go right to the edge like yours

[M0IVJ]

Hi, I used a display stands, cut it to length to mount the screen into the box. I tried a couple and the one in the link gave good support without bending. It needs slightly longer mounting screws, and I had to glue the brackets in place to stop the screen moving sideways. https://www.thingiverse.com/thing:1354900
73s John