BATC Forum

Having surprised myself and successfully put together a portsdown 4 and built the ryde rx …I have a query on the Ryde front panel board .

I have on the GPIO breakout board from the pi ..omitted R2 as stated

I am using the recommended TSOP2438

On the ryde schematic there is a JP1 listed ….but I have not found this anywhere on the Ryde front panel board ….does this link need to be in place somewhere…

https://wiki.batc.org.uk/Ryde_Hardware#Ryde_front_panel

I haven’t fitted the TSOP2438 yet ….but the Ryde seems to respond to the push buttons ok

Any suggestions helpful or otherwise gladly received….but I can find no reference to JP1 anywhere on the wiki pages

Steve G4HTZ

Turn the board over and look at the other side... JP1 selects 3.3V or 5V IR sensors. Use a 3.3V sensor and set that jumper to 3.3V.

Mike

Thanks mike
Will check that out next time I venture to the shed shack !!!
Using the recommended device which is 3.3v
Regards
Steve

Maybe this helps.

.

g0mjw wrote: ↑

Wed Dec 15, 2021 7:22 pm

Maybe this helps.

.
RydeFrontpanelBack.jpg

Hi mike
Thanks for that ….obvious now