Portsdown stream receiver input

[KA5BBC]

How does one build, configure, and implement the Portsdown stream receiver input for the repeater controller?

I'm assuming that I would need to build a Portsdown for each stream input (hopefully headless rather than needing more screens etc.) but where do I go from there?

[G8GKQ]

Andy

The recommended solution is not to use a Portsdown, but to use a Ryde for the stream input. This is of course headless and does not need an IR remote control. It is all configured in the config.yaml file.

Dave

[KA5BBC]

Thank you again Dave..

There is a bit of a learning curve but I will get there.

I have no doubt that there will be many many more questions before I am done