Repeater ON0TVO with ryde to scan 6m and 10m on 1 Ryde receiver

[ON5KR]

Hi All,
How do i configure the yaml file to scan 51.700MHz 125Ks and 250Ks and 10m 125Ks and 250Ks ? Both with correction for converter?
The one on A and the other on B?
Is that possible?
People who want to see the repeater srt://srt.on0tvo.be:10000
Greetings,
ON5KR

[Pa3fbx]

Hello, Basically you cannot..

You cannot select the port TOP/Bottom in 1 selection..
You can select several Symbol rates and/or frequencies to scan in a preselection but to select an other port you need a new preselect.
This is exactly what the other discussion was about.

viewtopic.php?f=130&t=9313

So you must figure out a way to change the preselect (channel + or -)
One way would be deleting all the preselections and only leave the 2 you need.
Than you toggle the channel + or - button GPIO to select either preselect..

Or you need some remote control like i made in our pi6mep repeater with node-red commands..
creating a TCP message.

Let me know if you have more Q's.

Benno, PA3FBX.

[ON5KR]

Thank you Benno!
I will look into it.

Kind regards,

73's ON5KR