Picotuner stl

Discussion about the MiniTiouner board and the MiniTiouner Digital ATV Receive Software. See also http://www.vivadatv.org/index.php
Post Reply
F1CJN_alain
Posts: 95
Joined: Thu Jul 21, 2011 9:50 am

Picotuner stl

Post by F1CJN_alain » Fri Nov 21, 2025 11:00 pm

I printed the Picotuner front face from the BATC stl file, months ago and it was fine.
I think now the BATC file has been changed (little hole near the power plug) but the two square holes for power and usb do not fit at all with my Pico rev3 board.
Where can I get the previous file ?
73s
Alain F1CJN
Top
Post Reply

Return to “The MiniTiouner and MiniTioune Digital Receive Software”