Hi,
after reading most of the post in this thread:
Can I use a MiniTiouner Pro v1 as part of the Ryde receiver or is only the standard MT usable? Any experience in this aera?
When can I expect that the PCBs for the Ryde will be available in the shop again?
Thanks
Rainer, DG8KD
Will a MiniTiouner Pro work as Ryde receiver?
Re: Will a MiniTiouner Pro work as Ryde receiver?
I don't see why not. Plug in and see?
The PCBs are being ordered but you don't need them to test it. You can do limited control through SSH which will at least demonstrate compatibility but you can also wire a 3.3V IR sensor up to the GPIO with dupont cables, that's what I did initially, probably what others did too.
Mike
The PCBs are being ordered but you don't need them to test it. You can do limited control through SSH which will at least demonstrate compatibility but you can also wire a 3.3V IR sensor up to the GPIO with dupont cables, that's what I did initially, probably what others did too.
Mike
Re: Will a MiniTiouner Pro work as Ryde receiver?
Thanks Mike for the quick reply.
First I have to order the RP4, only 2 and 3B in by craft box, then I will give it a try.
73
Rainer
First I have to order the RP4, only 2 and 3B in by craft box, then I will give it a try.
73
Rainer