Hi Franck - did you try setting the locale like I suggested? It would at least eliminate that as a reason. Also don't forget to disable the firewall and any anti-virus software to see if its being blocked.
This forum is run by the BATC (British Amateur Television Club), it is service made freely available to all interested parties, please do not abuse this privilege.
Sorry Mike, I forget you I try to change Local , same problem.
Charles , my config Vmix is the same that your dump screem.
I start to believe that my pluto has a problem, yet it works very well with SDRAngel, it's a funny story ...
You can see the interrupts on Titioun monitor. Same problem on 1249Mhhz >>> no Synchro (PID are 33/49 in datvexpress) Franck
My signal is not good. I have try to test it with IIO Oscilloscope ( software from Analog device and cable short) , and I think there are a problem.
look, marker at 1255 (P0) is -7db at the left side.......
But after adjust the parameters in IIO Scope, my signal is best, but I think I have problem with my TX Pluto output, because PO marker is not stable , and the signal level PO is low. If some one can released this mesure to compare....
.https://wiki.analog.com/resources/tool ... cilloscope
Thk's 73 Franck
Happy new year. Just for information my Pluto run very well now, it was an offset ajustment with my Minitioun.
I have test differents frequency, mods, SR > 500, it's ok 100%.
Thank you for your support.
The tablet used to work with the LP10 release as I have been using it extensively as a signal generator for amp experiments. Indeed SEEMS to work (able to select capture devices so PTT becomes active) however when PTT is clicked the TX Queue shows 0% and I'm getting NO rf.
I've refreshed the drivers for the Pluto from the link in the latest manual and also 'repaired' (windows words) the Microsoft Redistributable Visual C++ (32-bits). The Pluto shows up as a com port as per the manual too.
I'm wondering what else I could try? It was so handy......
https://github.com/analogdevicesinc/plu ... /tag/v0.30
I have tested it with the DATV-Express Software and it still works.
If anything the new S/W appears to have slightly improved the USB2 performance
it now seems quite stable at 4MSymbols/sec.