Rpi Model B I Q wiring

The place for discussion about the RPi add-on RB-TV modulator card developed by G4EWJ and supported by the BATC Shop
Post Reply
G4KLB
Posts: 198
Joined: Wed May 28, 2008 10:46 am

Rpi Model B I Q wiring

Post by G4KLB » Mon May 18, 2015 12:09 pm

If You have a Raspberry Pi Model B, (not B+) only one of the I Q signals is connected to the gpio header.

The 'I' is already connected but you will need to run a wire to connect the 'Q' as detailed in the instructions.
The photo in the BATC article is a little small to see where to connect it, so am posting it here.
Attachments
IMAG2185.jpg
IMAG2185.jpg (910.32 KiB) Viewed 1828 times
IMAG2183rs.jpg
IMAG2183rs.jpg (183.73 KiB) Viewed 1828 times

Post Reply

Return to “DigiThin”