I am just putting a few thoughts on down on here using the article in CQ-TV263 on required power levels. I know it is a bit out of date with respect to the MER of the beacon, but think it matters little.
If I had a 1.2m dish then the reference was 8dB MER with a 1 m dish it was 7 dB MER
So with the same 1m dish for TX and RX, The power level at the feed to give an MER of 7 dB, at 250KS with a 0.35 roll off that was said to be 43 Watts with an efficiency of 50%.
I have a 1.05 m dish,and believe from a few on line calculators to have close to 0.4 dB gain on the 1 m
So I tested my own signal at as close to 7.4 dB MER as I could make it when there was no other stations on board, ( apart from beacon ) also I tested on the slot near to the beacon as that seems to be the quietest with respect to noise and I needed 42 Watts at the PA output.
I have set 0.5 dB cable/connector loss so think at my feed point I have 37.4 Watts, I think I get an efficiency of around 0.575 or 57.5 % although, I am not sure if I am making up for the 0.4dB enough?
But it may be a better figure then just guessing I have 70% efficient antenna?
Adrian
p.s. I am eagerly awaiting any guidance to be given from the Microwave soc and others as well as the final submission of the calcs etc from the RSGB on the 7th June? But it is fun to try and work things out, it keeps the grey cells active.
Help with calcs for the safety rules QO-100
Discussion and announcements about ATV related spectrum
Re: Help with calcs for the safety rules QO-100
Post by AdrianH » Fri Jun 04, 2021 2:47 pm
G8UGD
https://qsl.net/g8ugd
https://qsl.net/g8ugd
Jump to
- Forum Admin
- ↳ Announcements
- ↳ Feedback
- ↳ New BATC WebSite and Online Shop
- ATV General Discussion
- ↳ Getting Started?
- ↳ General ATV Discussion
- ↳ DATV - Digital ATV
- ↳ The Portsdown Digital ATV System
- ↳ The Ryde Digital ATV Receiver
- ↳ ARISS HamTV
- ↳ The WinterHill DATV Receiver
- ↳ The Knucker DVB-T Tuner and Receive Software
- ↳ OpenTuner DATV Receive Software
- ↳ The MiniTiouner and MiniTioune Digital Receive Software
- ↳ LimeSDR Mini
- ↳ Es’hail-2 - DATV Transponder
- ↳ CAT 23 - Midland Air Museum Coventry 6 August 2023
- ↳ CQ-TV, The BATC Magazine
- ↳ ATV Activity and Contest Discussions
- ↳ BATC Bursary Grants
- ↳ Spectrum matters
- ↳ Streaming
- ↳ EMF Compliance
- ↳ Narrow Band DATV (RB-TV)
- ↳ Broadcast Equipment Discussion Zone
- ↳ DXSpot.TV
- ↳ Deutschsprachiges Forum
- ↳ Portsdown DATV Projekt - Deutschsprachiges Forum
- ↳ Minitioune(r) - Deutschsprachiges Forum
- ↳ Events
- ↳ Early Digital ATV Equipment
- ↳ DigiThin
- ↳ DigiLite
- ↳ BATC DTX1
- ↳ The Langstone Microwave Transceiver
- ↳ CaribouLite RPi Hat
- Adverts
- ↳ For Sale
- ↳ Wanted
- ↳ BATC Shop
- ATV Repeaters
- ↳ UK ATV Repeaters
- ↳ UK Repeater Details Moving to the BATC Wiki
- ↳ UK ATV Repeater News and Discussion
- ↳ GB3BH
- ↳ GB3CZ
- ↳ GB3DK
- ↳ GB3EN
- ↳ GB3ET
- ↳ GB3EY
- ↳ GB3FB
- ↳ GB3FT
- ↳ GB3FW
- ↳ GB3FY
- ↳ GB3GG
- ↳ GB3GV
- ↳ GB3GW
- ↳ GB3HV
- ↳ GB3IF
- ↳ GB3IT
- ↳ GB3IV
- ↳ GB3JT
- ↳ GB3KM
- ↳ GB3LO
- ↳ GB3LX
- ↳ GB3MV
- ↳ GB3NQ
- ↳ GB3NV
- ↳ GB3PV
- ↳ GB3RT
- ↳ GB3RV
- ↳ GB3SQ
- ↳ GB3TG
- ↳ GB3TM
- ↳ GB3TN
- ↳ GB3TT
- ↳ GB3TV
- ↳ GB3TZ
- ↳ GB3UD
- ↳ GB3VR
- ↳ GB3UT
- ↳ GB3VL
- ↳ GB3VV
- ↳ GB3VX
- ↳ GB3WV
- ↳ GB3YT
- ↳ GB3ZZ
- ↳ Internet-only Repeaters
- ↳ IO91LC
- ↳ IO91WN
- ↳ IO92GQ
- ↳ Overseas ATV Repeaters
- ↳ ATV Repeater Technical Topics
- Archive
- ↳ GB3AT
- ↳ GB3FT
- ↳ GB3FV
- ↳ GB3CT
- ↳ GB3AD
- ↳ GB3BG
- ↳ GB3DH
- ↳ GB3DJ
- ↳ GB3KT
- ↳ GB3NV
- ↳ GB3OT
- ↳ GB3PT
- ↳ GB3TB
- ↳ GB3TX
- ↳ GB3VW
- ↳ GB3XG
- ↳ GB3XT
- ↳ GB3XV
- ↳ GB3XY
- ↳ GB3YT
- ↳ GB3YX
- ↳ For Sale Ads Archive
- ↳ Wanted Ads Archive
- ↳ CAT 13 - Finningley 26/27 October 2013
- ↳ CAT 14 - Basingstoke 6/7 September 2014
- ↳ CAT 15 - Finningley 5/6 September 2015
- ↳ CAT 16 and BGM 2016
- ↳ CAT 17
- ↳ CAT18
- ↳ Mini-Conventions in 2019
- ↳ CAT 20 - Online 24 October 2020
- ↳ CQ-DATV, the e-book magazine
- ↳ CAT 21 - Part 2 Online Saturday 16 October 2021
- ↳ CAT 22 - Online 22 October 2022