BATC Forum

Hello members,

I do not get it anymore.
The manual of the mini tiouner states that before you want to use the mini tiouner, you must first check the programs to ensure they are functioning properly and the green lights must be on. Until last Saturday they were on green, and I had programs from a few `s 90% in the green display.
Since last night I can't get it to work anymore, and no matter what I try the lights stay red and the program stops.
I have already tried the USB ports several times, but nothing
Help

Do you have access to another PC that you can load the Minitioune software on and it on try that computer? If not I'd try another USB cable after removing and reinstalling the Minitioune software on your current PC. I am assuming all power supplies on the Minitiouner board are present and correct? Good luck!

it works again, another USB cable.
cause ; unknown.
a question; how should I program it; Use Tioune Data Reader V0.2b.
And a few parts of ; USB master (lnb / 22Khz Ts1 and Ts2) buttons do not work and USB aux does not work.
Why is that? Use the Mini-Tiouner Express.

And, can someone tell me what to do to get that working.

Best regards

thedvbdreamer1 wrote: ↑

Mon Sep 25, 2023 7:42 pm

And a few parts of ; USB master (lnb / 22Khz Ts1 and Ts2) buttons do not work and USB aux does not work.
Why is that? Use the Mini-Tiouner Express.

They don't work because they are not implemented in that model.

Mike

g0mjw wrote: ↑

Tue Sep 26, 2023 7:32 pm

thedvbdreamer1 wrote: ↑

Mon Sep 25, 2023 7:42 pm

And a few parts of ; USB master (lnb / 22Khz Ts1 and Ts2) buttons do not work and USB aux does not work.
Why is that? Use the Mini-Tiouner Express.

They don't work because they are not implemented in that model.

Mike

Oke ,thank you Mike

Mvg