Cold light source
Posted: Fri Nov 20, 2020 4:56 pm
If you're working on pcb design and build good lighting is essential, especially with the smaller SMD pieces...
I have two cold source fibre optic light units surplus to my requirements.
Meiji Techno FL-150 Fibre Optic Light Source. -- ***SOLD***
and a
Schott KL-750
Both are in fully working order, quite clean with a few marks as would be expected - each with a new bulb installed.
£50 each.
Each one weights 4.5kg, so postage would be £7.50 (to the mainland UK), or can be collected from Hook, Hampshire RG29 1BH.
73
Frank, M0AEU
I have two cold source fibre optic light units surplus to my requirements.
Meiji Techno FL-150 Fibre Optic Light Source. -- ***SOLD***
and a
Schott KL-750
Both are in fully working order, quite clean with a few marks as would be expected - each with a new bulb installed.
£50 each.
Each one weights 4.5kg, so postage would be £7.50 (to the mainland UK), or can be collected from Hook, Hampshire RG29 1BH.
73
Frank, M0AEU
- _DSC5559.jpg (1001.73 KiB) Viewed 2085 times
- _DSC5499.jpg (1.12 MiB) Viewed 2085 times
- _DSC5504 (1).jpg (1.08 MiB) Viewed 2085 times
- _DSC5558.jpg (1002.58 KiB) Viewed 2085 times