Page 1 of 1
Portsdown stream receiver input
Posted: Sun Jul 06, 2025 7:07 pm
by KA5BBC
How does one build, configure, and implement the Portsdown stream receiver input for the repeater controller?
I'm assuming that I would need to build a Portsdown for each stream input (hopefully headless rather than needing more screens etc.) but where do I go from there?
Re: Portsdown stream receiver input
Posted: Sun Jul 06, 2025 7:51 pm
by G8GKQ
Andy
The recommended solution is not to use a Portsdown, but to use a Ryde for the stream input. This is of course headless and does not need an IR remote control. It is all configured in the config.yaml file.
Dave
Re: Portsdown stream receiver input
Posted: Sun Jul 06, 2025 8:03 pm
by KA5BBC
Thank you again Dave..
There is a bit of a learning curve but I will get there.
I have no doubt that there will be many many more questions before I am done
Re: Portsdown stream receiver input
Posted: Mon Jul 07, 2025 8:29 pm
by KA5BBC
OK.. Ryde is built enough to operate a stream receiver.
(I am waiting for components to populate the GPIO breakout and control boards I have)
How do I configure it so that those given a suitable IP and log in can access the repeater?