After several months I successfully completed my Digilte build for 70cm and
connected it to a power supply and it was drawing 150mA...great..!.
After reading page 20 of cq-tv235 Initial DC voltage settings and I quote
Mine are exactly the opposite R29 and R30 I and Q Bias have 4 volts onSliders of I & Q Bias presets R29/R30 should be set to midway initially
(2.1v on sliders) Set I & Q Level presets R16/R23 to mid-way. ( 4v on there sliders)
the wiper and R23 and R16 have 2.1 volts on there wipers. Know either
I have made an error during construction or this is just a typo...?
It also says in cq-tv page 20 that the output leg of my MIMIC should be 4 volts
but mine is only 1.75 volts..! The led flashes twice a second when no data and
not in TX mode. All the regulators are correct and working and the FT2232H
interface is installed and working and the LED flashes ounce every a second
when in TX mode. has anyone else had this problem or have a solution..!