1.3GHz filter design

Ideas, technical topics, help and discussion for ATV enthusiasts
Forum rules
This forum is run by the BATC (British Amateur Television Club), it is service made freely available to all interested parties, please do not abuse this privilege.

Thank you
Post Reply
markaren1
Posts: 59
Joined: Sat Sep 10, 2011 8:49 pm

1.3GHz filter design

Post by markaren1 » Thu Oct 13, 2011 7:31 pm

Hi All,

Just working on field trials of DigiLite-ZL (http://www.idesignz.org/DigiLiteZL/DigiLiteZL.htm) and need a half reasonable filter between the survey antenna and a portable DVB-S RX.

Current thoughts are to hand build an interdigital design using strips of FR4 + copper, maybe 2mm wide as the resonators, grounded at one end and tuned using low value Johanson PTFE trimmers at the hot end. Resonators will be somewhat short than quarter-wavelength and will be glued to a ground plane.

50R feed point will be a few % from the cold end, and probably need 5 poles (?) to achieve > 40db rejection at +-100MHz.

This really seems like the sort of thing that should have been done before, and before I grapple with uWave office (or ask some kind soul to) I am hoping that someone may have pointers to prior art.

I looked at PCB hairpin filters, but performance and centre freq is dominated by variations in batch to batch FR4 laminate manufacture. I considered using Rogers laminate, but this is not readily available so I am planning to stick with FR4 for the moment.

Thoughts and pointers please.

Thanks,

Mark
ZL3JVX etc.

User avatar
G8ADM
Posts: 115
Joined: Sat Feb 23, 2008 7:14 pm

Re: 1.3GHz filter design

Post by G8ADM » Sat Oct 15, 2011 11:14 am

Alternatively you can buy suitable filters from:

http://www.bvdavies.org.uk/filter/index.htm

or

http://www.id-elektronik.de/en/index.htm

Regards,

Dave.
G8adm

Post Reply

Return to “General ATV Discussion”