BATC Forum

Morning all need some help with DATV-Easy. I recently added a second NVME drive in my laptop. It had a 500Gb, but this was becoming very full. The second NVME is a 1Tb and is faster than the original one, so once I installed it I cloned the smaller drive to the new 1Tb drive. This seemed to go fine and everything I've used has worked fine, except DATV-Easy. The program runs but when you press start the two green LEDs light but the bit rate remains at zero and the lime doesn't initialise (green flashing led). I tried deleting DATV-Easy, both folders and removed all mentions of it in the registry with no change to it's behaviour. I know the lime is working as SDRconsole and SDR++ work fine with it. So I switched back to the old drive and it it worked fine.

Any ideas ?

73 John G7JTT

Ok so I bit the bullet this morning and re-cloned the new drive and I'm glad to report DATV-Easy is now working it would still of been nice to know what caused it not to work, but hey who cares it's working again

73 John G7JTT

Sometimes when you "clone" a drive not all files get locked and unlocked files may not copy across successfully.

A HUGE sigh of relief John.. you can sleep tonight
N

It used to be so easy cloning drives but I guess that's progress ! And yes definitely will be able to sleep tonight

73 John G7JTT