BATC Forum

I intercepted a Sky mesh dish a few days ago, unfortunately missing its LNB arm. I can replicate the arm if I knew the length of it. The LNB/radiating element/holder will be a 3-D printed adaptor to suit its new life, so it really is only the arm length I need. If anyone could run a tape measure over theirs I'd be grateful.
I've the smaller one, but logically it won't be the same. This dish measures 70cms across as per the pic.
Thanks
Gareth

hi Gareth,
not exactly what you are asking for...but this file will give you the position of the LNB and it's inclination as well.

best 73
de
i2NDT Claudio

Thanks Claudio, a very useful piece of work. Should be good enough
Gareth

Hi Gareth
I have the same dish ..width is as per your measurement is the same …feed arm from dish face to end of arm is about 305mm

Regards
Steve G4HTZ

Thanks Steve, I'll add it to my to-do list
Gareth