Page 1 of 1

QO-100 beacon MER

Posted: Thu Oct 29, 2020 8:41 pm
by g8gtz
As mentioned on the BATC Thursday night net, it would be good to know what MER people are getting the beacon at so others know how well (or not) their system is performing:

G8GTZ - 1.2mt dish - MER 9.6 and D4.8

73

Noel

Re: QO-100 beacon MER

Posted: Thu Oct 29, 2020 10:37 pm
by M0DTS
8.9dB using 1m dish and no other signals on the sat.
Octagon green 4-port LNB.
Cherry tree is causing some degradation though....

Rob

Re: QO-100 beacon MER

Posted: Thu Oct 29, 2020 10:44 pm
by g0mjw
This evening on the net it was around 10.5 measured by Winterhill. It's peaking 11.5 now, range 11.3-11.5 on the Ryde. That's probably partly the difference in the tuners and partly there are no other signals at the moment.

The lift in the noise floor was about 5 dB in August 2019., it's less now the trees have grown again.

Mike

Re: QO-100 beacon MER

Posted: Thu Oct 29, 2020 11:29 pm
by G8GKQ
1.2m offset dish, POTY, MER 9.5dB on an Empty Transponder.

Dave

Re: QO-100 beacon MER

Posted: Fri Oct 30, 2020 9:06 am
by arthur21
Empty band and a 1m offset dish MER 9.5 ( rx only dish ) Octagon lnb
73 G4CPE

Re: QO-100 beacon MER

Posted: Fri Oct 30, 2020 12:13 pm
by Don_EI8DJ
Mer 9.1 on 1.1m offset dish with octagon lnb
regards to all

Re: QO-100 beacon MER

Posted: Fri Oct 30, 2020 6:19 pm
by G4KLB
1.2M offset dish, Bullseye LNB.
Beacon is 10.6dB MER D6

Re: QO-100 beacon MER

Posted: Sat Oct 31, 2020 6:58 am
by g4hiz
Beacon reception at JO01fg, 06.37, 31/10. Wx cloudy/overcast but dry, very breezy.

Antenna 1.2m prime focus. LNA Octagon, H-pol (18V) with modified LO @ 9.389GHz, using POTY. Receiver Minitiouner (Serit tuner).

Transponder traffic: beacon plus one low NB carrier

Using Minitioune on laptop, s/w V0.9_9.1h MER 10.7 to 10.9dB, D6

Using Longmynd on Portsdown, s/w 202010180 MER 10.8 to 11.0dB

73
Jen

Re: QO-100 beacon MER

Posted: Sat Oct 31, 2020 8:32 pm
by G8XZD-TV
sky zone 2 dish empty transponder 6.2mer

Re: QO-100 beacon MER

Posted: Tue Nov 10, 2020 6:11 pm
by g8gtz
Thanks for the responses.

I've been monitoring the MER using the Portsdown large screen readout and seen a variation of 3dB between 10db on an empty transponder and 7dB with the useage below!

A single large signal can drop the MER by 1 dB - something to be aware of when tweaking your dish!


busy.JPG
busy.JPG (62.05 KiB) Viewed 7074 times

73 Noel - G8GTZ