Using SDRconsole on QO100 ATV co-ordination channels
Forum rules
This forum is run by the BATC (British Amateur Television Club), it is service made freely available to all interested parties, please do not abuse this privilege.
Thank you
This forum is run by the BATC (British Amateur Television Club), it is service made freely available to all interested parties, please do not abuse this privilege.
Thank you
Re: Using SDRconsole on QO100 ATV co-ordination channels
Can't remember Adrian I'll check later when I finish, sometime around 3pm hopefully.
Re: Using SDRconsole on QO100 ATV co-ordination channels
Hi Adrian ok try to set Tx to auto and Rx LNAW then set Tx to a ham band frequency
Re: Using SDRconsole on QO100 ATV co-ordination channels
3 steps forward 2 steps back!
Well due to a coughing fit I found that the vox appears to key the Tx!!
So as the Lime I understand works duplex ..I tuned to my tx freq expecting to see a big signal appear!
Nothing appeared! I still can not click on the TX button..and I suspect I may just be seeing the Vox system working
TX Tone Tune and drive being still greyed out...although the TX square does go Yellow when Vox is keyed!
I always felt that the Minitune once mastered was worthy of a good pass at O Level
If I ever hack this it's got to be worth a PHd!
Well due to a coughing fit I found that the vox appears to key the Tx!!
So as the Lime I understand works duplex ..I tuned to my tx freq expecting to see a big signal appear!
Nothing appeared! I still can not click on the TX button..and I suspect I may just be seeing the Vox system working
TX Tone Tune and drive being still greyed out...although the TX square does go Yellow when Vox is keyed!
I always felt that the Minitune once mastered was worthy of a good pass at O Level
If I ever hack this it's got to be worth a PHd!
- Attachments
-
- Screenshot (39).png (289.85 KiB) Viewed 3483 times
Re: Using SDRconsole on QO100 ATV co-ordination channels
A bit more info ..I clicked the record button whilst the vox was keyed but although I could see the audio spektrum bouncing up and down ..the recording was blank
Re: Using SDRconsole on QO100 ATV co-ordination channels
If you have a greyed out TX box its normally because 750KHz isn't selected
Re: Using SDRconsole on QO100 ATV co-ordination channels
Just for info there is a bug in 3.0.7 in that if the TX window is floating TX won't work. So you must have it docked this is to be fixed in the next release.