Callsign overlay for 5665MHz setup.

Ideas, technical topics, help and discussion for ATV enthusiasts
Forum rules
This forum is run by the BATC (British Amateur Television Club), it is service made freely available to all interested parties, please do not abuse this privilege.

Thank you
Post Reply
Posts: 7
Joined: Thu Mar 09, 2017 12:42 am

Callsign overlay for 5665MHz setup.

Post by M1BKF » Fri Sep 08, 2017 5:23 pm

I've been playing with the FPV video modules and wanted to overlay my callsign on the video stream. There are cheap, small, arduino-based boards "MinimOSD" that also are for drone FPV. The firmware for these is open source and very feature-full, but most of these features aren't needed just to overlay a callsign. So I took the firmware (others seemed not to compile on the current arduino environment) and gave it a very substantial pruning. The result is here:
Here's how I boxed it up, pending addition of an amplifier module.
5665MHz_tx.jpg (299.75 KiB) Viewed 866 times

Post Reply

Return to “General ATV Discussion”