23cm atv
Posted: Tue Jun 28, 2016 8:46 pm
Hi All
After a lot of a work got 23 cms to work controller and rx board from MobiComm I have a lot of white on picture any i dear how to fix it just started to test as next is to try for gb3pv out side of Cambridge will report back after test at weekend how do you get test card to transmitter and were can i find temp pleats from hope to make it all portable when done just got to work out power supply as need 12v+ and 13.8v+ plus 8v= so still got to build power box yet
The set up here is a MobiComm receiver and controller TX is a TSIM Board
I have made a beam 19 ele yagi and a dish with qued for receive
from Kevin g7vnp
After a lot of a work got 23 cms to work controller and rx board from MobiComm I have a lot of white on picture any i dear how to fix it just started to test as next is to try for gb3pv out side of Cambridge will report back after test at weekend how do you get test card to transmitter and were can i find temp pleats from hope to make it all portable when done just got to work out power supply as need 12v+ and 13.8v+ plus 8v= so still got to build power box yet
The set up here is a MobiComm receiver and controller TX is a TSIM Board
I have made a beam 19 ele yagi and a dish with qued for receive
from Kevin g7vnp