Motorola MHW2723
Forum rules
This forum is run by the BATC (British Amateur Television Club), it is service made freely available to all interested parties, please do not abuse this privilege.
Thank you
This forum is run by the BATC (British Amateur Television Club), it is service made freely available to all interested parties, please do not abuse this privilege.
Thank you
Re: Motorola MHW2723
Thanks for the info Dave, I didn't find that one!
Regards
Colin G4KLB
Regards
Colin G4KLB
Re: Motorola MHW2723
Does anyone know where I can get one of the Modules, tried all the suppliers I can think of and there are none on ebay.
Cheers
Terry
G6CRF/G0CRF
Cheers
Terry
G6CRF/G0CRF
Re: Motorola MHW2723
Terry how about this module looks similar may be able to adapt to the board.
seeing that none of the mhw are about have been searching myself.
http://html.alldatasheet.com/html-pdf/1 ... 57745.html.
Keith G0KTD
seeing that none of the mhw are about have been searching myself.
http://html.alldatasheet.com/html-pdf/1 ... 57745.html.
Keith G0KTD
Re: Motorola MHW2723
3 years on I know, but did anyone ever get one of these working properly on 70cms?
I remember at the time mine went unstable and I'm trying to get one working on a Portsdown and get the same problems with instability....
73 Noel
I remember at the time mine went unstable and I'm trying to get one working on a Portsdown and get the same problems with instability....
73 Noel
Re: Motorola MHW2723
Hi Noel,
I tamed mine by playing with the bias voltage.
I replaced the 0Ohm resistor on the output of the regulator with a 500Ohm pot, the metal shrouded ones used for I/Q bias on the DigiLite boards sit across the tracks quite well.
My module settled down with 4.3Volts on the bias pin.
73
Dave
I tamed mine by playing with the bias voltage.
I replaced the 0Ohm resistor on the output of the regulator with a 500Ohm pot, the metal shrouded ones used for I/Q bias on the DigiLite boards sit across the tracks quite well.
My module settled down with 4.3Volts on the bias pin.
73
Dave
Re: Motorola MHW2723
Cracked it - copper tape around the edge of the board to bond between upper and lower plus adjustable bias.
Driven directly by the Portsdown gives 8 watts with 30+ shoulders on 2Ms and 40+ on 333Ks in a nice compact unit - needs a big heatsink and blowing...
73 Noel
Driven directly by the Portsdown gives 8 watts with 30+ shoulders on 2Ms and 40+ on 333Ks in a nice compact unit - needs a big heatsink and blowing...
73 Noel