These are the correct rubber loops to secure the cables to the guide bars. Our stores did not provide quite enough! so we hope someone is able to help.
They are marked Insuliod size 4 and 5 and we need about 12 size 5 and 5 size 4 or thereabouts.
Photos show:-
The Loops ( size 4)
Close up
The back of the technical tailboard on MCR21 www.mcr21.org.uk
The front of the technical tailboard.
Need to find the right thing for originallity. Hope you can help.
I did try using rubber "o" rings which looked most promising, but after a few weeks all of them had failed at the point were the ends were glued together. Apparently no use under tension!
Best regards
the MCR21 team. G8GQS
Another impossible item ! Insuloid cable cradle loop
Forum rules
This forum is run by the BATC (British Amateur Television Club), it is service made freely available to all interested parties, please do not abuse this privilege.
Adverts will be archived when the poster indicates that the item is found or after one year. If you wish to keep advertising after one year, please re-post.
This forum is run by the BATC (British Amateur Television Club), it is service made freely available to all interested parties, please do not abuse this privilege.
Adverts will be archived when the poster indicates that the item is found or after one year. If you wish to keep advertising after one year, please re-post.
Another impossible item ! Insuloid cable cradle loop
- Attachments
-
- original Vision Sound Camera tailbord_1.jpg (53.21 KiB) Viewed 57333 times
-
- DSC_7791.jpg (89.29 KiB) Viewed 57333 times
-
- DSC_7792.jpg (40.82 KiB) Viewed 57333 times
-
- DSC_7793.jpg (31.43 KiB) Viewed 57333 times
-
z twin page list Sept 2023 1.pdf- (1.44 MiB) Downloaded 379 times