Ryde Receiver / IR remote control / Tuning
Posted: Wed Nov 26, 2025 9:37 am
Hi all,
I recently built a Ryde receiver and I reused an old Sony remote control to use it .... For this purpose, I created a "customized configuration" and shared it with the following post:
viewtopic.php?t=6759&start=60#p38321
All this works but the remote control is quite tricky to use , a little bit too sensitive => I often experience double-clicks which resulst in not being a the right location on the menus
I think I should tune one of the following paramenters in the yaml file ? But which one ?
ir:
repeatFirst: 200
repeatDelay: 100
repeatReset: 400
Any advice on this ?
In advance thank you !
Best 73s
Christophe F5IWN
I recently built a Ryde receiver and I reused an old Sony remote control to use it .... For this purpose, I created a "customized configuration" and shared it with the following post:
viewtopic.php?t=6759&start=60#p38321
All this works but the remote control is quite tricky to use , a little bit too sensitive => I often experience double-clicks which resulst in not being a the right location on the menus
I think I should tune one of the following paramenters in the yaml file ? But which one ?
ir:
repeatFirst: 200
repeatDelay: 100
repeatReset: 400
Any advice on this ?
In advance thank you !
Best 73s
Christophe F5IWN