GPIO input to change Ryde F type input
Posted: Sat Nov 15, 2025 4:24 pm
Is there any chance of a version of Ryde software where a GPIO input could switch the frequency and input F type so that a repeater controller could switch between frequencies and aerials? This would allow a repeater to experiment with different frequency inputs without a great expence or modification. For example on GB3NQ we have 2m, 70cms, 23cms, Oscar 100 and a stream input. As an experiment one of these inputs could switch between say Oscar 100 and 71Mhz or 13cm etc. at certain times. If the experiment worked then another Ryde etc. could then be built.
Martin G8LCE
Martin G8LCE