RYDE front panel JP1 ???

Discussions about the Ryde "Set-top Box" Style Digital ATV Receiver. See https://wiki.batc.org.uk/Ryde_Receiver
Post Reply
G4HTZ
Posts: 217
Joined: Sat Aug 02, 2014 4:21 pm

RYDE front panel JP1 ???

Post by G4HTZ » Wed Dec 15, 2021 2:22 pm

Having surprised myself and successfully put together a portsdown 4 and built the ryde rx …I have a query on the Ryde front panel board .

I have on the GPIO breakout board from the pi ..omitted R2 as stated

I am using the recommended TSOP2438

On the ryde schematic there is a JP1 listed ….but I have not found this anywhere on the Ryde front panel board ….does this link need to be in place somewhere…

https://wiki.batc.org.uk/Ryde_Hardware#Ryde_front_panel

I haven’t fitted the TSOP2438 yet ….but the Ryde seems to respond to the push buttons ok

Any suggestions helpful or otherwise gladly received….but I can find no reference to JP1 anywhere on the wiki pages

Steve G4HTZ
Steve G4HTZ

ASHEN nr Sudbury JO02GB52 90m ASL

70cms DATV portsdown 4 + RYDE rx …14 or 18 ele yagi …LNA …hopefully 100w amp at some point

g0mjw
Posts: 2330
Joined: Sat Sep 20, 2014 9:15 am

Re: RYDE front panel JP1 ???

Post by g0mjw » Wed Dec 15, 2021 6:25 pm

Turn the board over and look at the other side... JP1 selects 3.3V or 5V IR sensors. Use a 3.3V sensor and set that jumper to 3.3V.

Mike

G4HTZ
Posts: 217
Joined: Sat Aug 02, 2014 4:21 pm

Re: RYDE front panel JP1 ???

Post by G4HTZ » Wed Dec 15, 2021 6:30 pm

Thanks mike
Will check that out next time I venture to the shed shack !!!
Using the recommended device which is 3.3v
Regards
Steve
Steve G4HTZ

ASHEN nr Sudbury JO02GB52 90m ASL

70cms DATV portsdown 4 + RYDE rx …14 or 18 ele yagi …LNA …hopefully 100w amp at some point

g0mjw
Posts: 2330
Joined: Sat Sep 20, 2014 9:15 am

Re: RYDE front panel JP1 ???

Post by g0mjw » Wed Dec 15, 2021 7:22 pm

Maybe this helps.

.
RydeFrontpanelBack.jpg
RydeFrontpanelBack.jpg (233.53 KiB) Viewed 3145 times

G4HTZ
Posts: 217
Joined: Sat Aug 02, 2014 4:21 pm

Re: RYDE front panel JP1 ???

Post by G4HTZ » Wed Dec 15, 2021 7:50 pm

g0mjw wrote:
Wed Dec 15, 2021 7:22 pm
Maybe this helps.

.
RydeFrontpanelBack.jpg
Hi mike
Thanks for that ….obvious now :oops:
Steve G4HTZ

ASHEN nr Sudbury JO02GB52 90m ASL

70cms DATV portsdown 4 + RYDE rx …14 or 18 ele yagi …LNA …hopefully 100w amp at some point

Post Reply

Return to “The Ryde Digital ATV Receiver”