Post
by G4NZV » Sun May 16, 2021 9:11 pm
Hi,
I do like the facility of being able to use a remote to control the Ryde receiver, it makes tuning very slick. However, I was caught out by this ‘feature’ during the DATV activity weekend…….
Please verify the following issue and consider a correction for inclusion in a future Ryde release if appropriate.
Ryde Receiver band change discrepancy between SSH and Remote control.
If SSH is used to control switching between bands the band change is as expected. E.g., if 146MHz band is chosen and a signal frequency of 146.5MHZ is transmitted Ryde-Minituner achieves lock. If the Ryde is stopped and the band is changed to 437MHz the transmitter also needs to be changed to 437MHz to achieve lock as expected.
IF the remote control is used to change bands the frequency the Ryde-Minituner is tuned to does not change. This was confirmed by performing the above test using the remote to control the Ryde.
My expectation is for Ryde band switching with the remote or by SSH to be the same. If that was not the intention then please ignore this post!
PS I have not tested every combination of band switching, LO programming, GPIO and frequency tuning. The Ryde version installed is version: 202103130
Steve G4NZV