MiniTiouner V2.0 Contruction

[G4MJW]

Thanks Gareth, Brilliant.

Just waiting for 100n bigger lead spacing than I have in my drawer.could have used them but I ordered 50, so I'll wait a bit. Be nice to actually hear something on it (Langstone RX with Pluto is good).

Thanks again

Steve

[G3GJA]

Just be aware that although the USB module is ready programmed, you do need to add a 10k resistor if you are going to use the later versions of the Minitioune software. Pin 10 of CN2 to ground as below.

10k.jpg (391.09 KiB) Viewed 5736 times

Clive

[G4MJW]

Thanks Clive . . . I did that this morning. Funny, I used a 10k (says 5.6k to 12k).

Watching, wating, hoping postman brings yo last capacitors today.

Thanks again.

Steve

[sv1coasv1coa]

Hello i have one problem with my minitiouner v2 every time I turn on the my computer, the minitiouner drivers is gone, and I have to reinstall again, what happen? my system is win 10.

[G8DGR]

Where did you get the PCB. The Shop says out of stock

[radiogareth]

If you are stuck I have a blank spare I could post you, (and an FTDI module too) but its likely the shop stock will be in hand.
Gareth

[g0mjw]

Hello i have one problem with my minitiouner v2 every time I turn on the my computer, the minitiouner drivers is gone, and I have to reinstall again, what happen? my system is win 10.

Which drivers? If you mean the USB then perhaps you have downloaded some other FTDI drivers that are conflicting? If you mean the graphics drivers perhaps they are corrupt or have a virus or something that the virus scanner thinks is a virus and are being removed or disabled.