Re: MiniTiouner v2 failing all tests
Posted: Tue May 19, 2020 12:10 pm
Hi perhaps you can advise me also. I have just built and provisionally tested a MiniTiouner v2.0. I have just done the last step of fitting the FT2232H board after confirming all voltages were OK. When I plug in the USB lead I get the two tones then I plugged in the 12v power lead. I got the setting up usb bubble which then disappeared. I ran the v0.8 software and ran the test program and all i get is NO USB DEVICE.
I went to the device manager and in other devices it says ! USB<-->NIM TUNER
? USB<-->NIM TUNER
I done all the usual re-boots,etc. I have even bought a LINDY USB lead just in case my original lead was no good, but to no avail. I have rechecked all voltages and confirmed that they are going to the correct places and these are correct, so now I am stuck. Any Ideas out there.
I went to the device manager and in other devices it says ! USB<-->NIM TUNER
? USB<-->NIM TUNER
I done all the usual re-boots,etc. I have even bought a LINDY USB lead just in case my original lead was no good, but to no avail. I have rechecked all voltages and confirmed that they are going to the correct places and these are correct, so now I am stuck. Any Ideas out there.