FTDI Module and drivers? Confused
Posted: Sun Aug 12, 2018 1:38 pm
I have just built up my first MiniTiouner, V2 board and FTDI module purchased from BATC at the Telford ATV Academy having trouble getting it running. Voltages are all okay, no white smoke etc. Installed the 10K resistor on the USB module and downloaded V8 of the software.
Power connected, then plugged in USB lead into Windows 7 PC (32bit) and it installs drivers but get four usb controllers, not 2 as I've seen in the documentation (as confusing as it is) tried on another PC and the same. The various test programs don't work can't recognise the receiver, downloading the FTProg program, shows a completely different device (FT4232H) to what I expected.. in the land of the very confused now.. is the USB module not programmed?
I have removed the drivers and devices and tried to run the driver install that comes with the software package but computer just makes an error sound and nothing else, even running it under the command prompt..
Any pointers would be helpful
Andrew
M0NRD
Various screenshots
Power connected, then plugged in USB lead into Windows 7 PC (32bit) and it installs drivers but get four usb controllers, not 2 as I've seen in the documentation (as confusing as it is) tried on another PC and the same. The various test programs don't work can't recognise the receiver, downloading the FTProg program, shows a completely different device (FT4232H) to what I expected.. in the land of the very confused now.. is the USB module not programmed?
I have removed the drivers and devices and tried to run the driver install that comes with the software package but computer just makes an error sound and nothing else, even running it under the command prompt..
Any pointers would be helpful
Andrew
M0NRD
Various screenshots