Minitiouner V1.0 3D Case ?
Minitiouner V1.0 3D Case ?
Hello
Minitiouner V1.0
did someone allready designed and printed a 3D Case for this tuner
If there exist ?
I searched on thingiverse, but found nothing
Could be helpfull
Tnx for any help ?
Otherwise , I have to give a go myself ..
ON7MA, Jemp
Minitiouner V1.0
did someone allready designed and printed a 3D Case for this tuner
If there exist ?
I searched on thingiverse, but found nothing
Could be helpfull
Tnx for any help ?
Otherwise , I have to give a go myself ..
ON7MA, Jemp
Re: Minitiouner V1.0 3D Case ?
I just used a standard Hammond extruded metal case for my V1. Much stronger. Looks good. Heatsinking. www.hammfg.com/electronics/small-case/extruded/1455
Mike
Mike
Re: Minitiouner V1.0 3D Case ?
Ok Mike tnx 4 answer
Can you show a pic ? of the construction ?
The FDDI Module on feet is getting quite high...
Can you show a pic ? of the construction ?
The FDDI Module on feet is getting quite high...
Re: Minitiouner V1.0 3D Case ?
I don't have an internal photo and it doesn't exist any more. Sorry.
Mike
Mike
Re: Minitiouner V1.0 3D Case ?
Merci JP,
I have version 1.0, this case best for other version.
I will try to design myself and put the the design here on the forum, for other people
JP
I have version 1.0, this case best for other version.
I will try to design myself and put the the design here on the forum, for other people
JP
Re: Minitiouner V1.0 3D Case ?
The other version won't fit in this case. It was for my V1 too. I used a 90 degree F-type and 90 degree USB extender to bring the sockets out of the back. I used the case itself to dissipate the heat from the regulators.
Mike
Mike
Re: Minitiouner V1.0 3D Case ?
JP,
Some pictures of my Minitioune v01.
Some pictures of my Minitioune v01.
Re: Minitiouner V1.0 3D Case ?
Oeps, some photo's lost.
Re: Minitiouner V1.0 3D Case ?
That's incredibly similar to what I did!