BATC Forum

Hi all
could someone please direct me to the user instructions for the Mini Tiouner software as
I am visiting varies heritage associations relating to communication & radio in Cornwall
so without any notes from home as I have just given a Mini Tiouner to the chairman of the
Poldhu radio club located at the Marconi center
Regards Paul B

Which MiniTiouner pcb do you have? V1 (green) or V2 (blue). If V1, which NIM (receiver module)?

The operation of the PC software is almost identical for both, but the frequency ranges are different and there are slight differences in selecting and powering the F sockets for preamps etc.

Brian

HI Brion
thank you for the posting OK on the different freq range but still looking for software user instructions
Paul B

Hi Paul,

No real manual exists as its not a commercial product and Jean Pierre is too busy writing software.

I put some basic instructions on the BATC wiki https://wiki.batc.tv/MiniTioune_software - it's a bit sketchy at the moment but may be enough to get you going.

Noel - G8GTZ