BATC Forum

Hello,
after a long time I put the Portsdown/Langstone with Pluto back into operation.
Of course updated.

Langstone works fine.

When using Portsdown, I had to set the Pluto (firmware 0303) to RTMP so that it would send. UDP didn't work.
Then it takes approx. 8 seconds until Pluto sends or until the broadcast is finished.

Is that correct? I can't remember it anymore...

73

To use the Pluto with the Portsdown, it must have firmware v0.31-4-g9ceb-dirty loaded. No other Pluto firmware versions are supported. https://wiki.batc.org.uk/Portsdown_4_Pl ... o_Firmware

Dave, G8GKQ

Thank you Dave