8 Band RF Switch V2.1 PCB Error
Posted: Sat May 12, 2018 1:36 pm
I haven't seen it mentioned elsewhere so I thought I would report the following so it doesn't catch out others.
Whilst assembling the 8 Band RF Switch on a V2.1 PCB under a microscope I noticed that the pads at the ground ends of R1 and R2 in the input attenuator were not connected to anything. It looks like the thermal relief connections to the surrounding ground plane were missed out from the PCB design.
It is easy enough to correct this, just scrape away a little of the solder resist next to the pads and add a blob of solder to join the pads to ground.
Colin G4EML
Whilst assembling the 8 Band RF Switch on a V2.1 PCB under a microscope I noticed that the pads at the ground ends of R1 and R2 in the input attenuator were not connected to anything. It looks like the thermal relief connections to the surrounding ground plane were missed out from the PCB design.
It is easy enough to correct this, just scrape away a little of the solder resist next to the pads and add a blob of solder to join the pads to ground.
Colin G4EML