Page 1 of 1

New Duplexer GB3ET

Posted: Tue May 26, 2020 8:01 am
by G8DKC
New Factory Tuned Duplexer Fitted by John to GB3ET,

Due to Switcher Fault We have re-directed digital output to IO92GQ GB3ET Link,
I hope to travel down to ET in the next month to refurbished system...

Going to IO92GQ GB3ET Link on repeaters page,
If you see the Blue Screen with invite to Tx, have a go as Rx (1249 2M/S) performance very much improved.

GB3ET Stream will be back on soon (off Air Stream Yagi changes), and then 1249 analog input available, same improvements.


Re: New Duplexer GB3ET Update...

Posted: Thu May 28, 2020 9:03 pm
by G8DKC
We are Streaming over 4G from site to IO92GQ GB3ET-Link.

Steve M0SKM Dunstable was giving his new P.A. a try out toward ET near Banbury.

I managed to get this frame dispite my flakey 4G stream.

Looking forward to his return, and I can update picture :)

And here it is!


Re: New Duplexer GB3ET

Posted: Wed Jun 03, 2020 3:20 pm
by M0SKM
Took the big PA off Peter and tried 18Watts from the Mitsubishi brick, you'll be pleased to know I can still access ET from Dunstable. I've also found a solution to the Portsdown rebooting when the beam comes round your way, see picture. Changing modes is slightly awkward now. :D

73 Steve

Re: New Duplexer GB3ET

Posted: Thu Jun 18, 2020 12:32 pm
by G8DKC
Hi Steve, M0SKM,

Sorry I missed this post, better late than never!

Hope you didn't have to queue?

2E0XAY, Steve in Leiester now getting in, added rain storms recently for best performance?

Thanks for update.


Picture from Steve's shack in Leicester.

Re: New Duplexer GB3ET

Posted: Tue Jun 30, 2020 7:00 pm
by G4FRE
No longer receiveable in Malvern IO82UC. Previously receiveable with a MER of ¬5dB

I did receive it in when portable in IO91BV82 on june 21 2020 with a MER of 9dB